ErrorCodeDoctor
Whirlpool · Dishwasher

Whirlpool Dishwasher F6 E1 error code

Difficulty: Easy · Cost: $0–$150 · Duration: 10–15m

The F6 E1 error means your Whirlpool dishwasher is not receiving water at the correct rate or pressure. This is most commonly caused by a closed water supply valve, a kinked supply hose, or low water pressure. Check the water supply connections first. Disconnecting power for 30 seconds clears the code after fixing the supply issue.

Common causes

  • Water supply valve is closed or not fully open
  • Water supply hose is kinked or not properly connected
  • Household water pressure is too low
  • Water inlet valve has malfunctioned

How to fix it

  1. 1

    Make sure the water supply valve under the sink is fully open

  2. 2

    Check the supply hose for kinks and straighten if needed

  3. 3

    Unplug the dishwasher or turn off the circuit breaker for 30 seconds

  4. 4

    Restore power and try running a cycle

  5. 5

    If F6 E1 returns contact a qualified technician or schedule service

Related Whirlpool Dishwasher error codes

1

E1

The overfill protection float has detected too much water or is stuck

easy
2

F1 E1

The main control board has detected a fault

hard
3

F2 E2

The door latch is not detecting the door as fully closed

easy
4

F3 E1

The thermistor or temperature sensor has a fault

hard