ErrorCodeDoctor
Whirlpool · Dryer

Whirlpool Dryer PF error code

Difficulty: Easy · Cost: $0 · Duration: 2m

The PF code means your Whirlpool dryer's drying cycle was interrupted by a power failure. This is most commonly caused by a power outage, a tripped circuit breaker, or the dryer being accidentally unplugged during a cycle. Touch and hold START to restart the cycle from where it left off, or press POWER to clear the display. If a recent power outage occurred with unusual voltage fluctuations turn off the circuit breaker for 1 minute then reset it and monitor the dryer.

Common causes

  • Power outage interrupted the cycle while the dryer was running
  • Circuit breaker tripped during the cycle
  • Dryer was accidentally unplugged while running
  • Unexpected voltage noise on the power supply line during a power outage triggered the code

How to fix it

  1. 1

    Touch and hold the START button to restart the drying cycle

  2. 2

    Or press the POWER button to clear the display and start a new cycle

  3. 3

    If a recent power outage occurred turn off the household circuit breaker for the dryer for 1 minute then reset it

  4. 4

    Monitor the dryer for 1 minute after resetting to confirm the error does not return

  5. 5

    If the dryer was recently installed and PF appears repeatedly contact a qualified electrician to verify the electrical supply

Related Whirlpool Dryer error codes

1

AF / F4 E3

Restricted airflow detected — the lint screen or exhaust vent is clogged or blocked

easy
2

L2 / F4 E4

Low or no voltage detected on one leg of the power supply — the heater cannot turn on

medium
3

Loc

Control Lock has been activated — the dryer will not start or operate

easy
4

F# E# (all other codes)

An internal fault was detected — the dryer control has detected a problem that requires service

hard