Whirlpool Microwave error codes

: or . in display

The display is showing a colon or dot — the microwave is in a standby or demo state

Call Service

The microwave detected a fault that cannot be resolved by the user — service is required

DOOR / OPEN and CLOSE DOOR

The microwave door is not closing or latching properly

Err7

A control board fault was detected

ERROR (during sensor cooking)

An error occurred during sensor cooking — the sensor could not detect steam correctly

F# E# / All other F and E codes

A component or system fault was detected — reset the circuit breaker to attempt to clear

F9 / F9 E0

The electrical outlet or connection may be miswired

Feature Not Available

The selected feature is not available on this microwave model

Locked / Lock / Loc

Control Lock is active — the microwave controls are disabled

Press Cancel to Reset

The microwave detected an issue and requires a manual reset

Probe / Insert Probe

The temperature probe needs to be inserted or is not connected properly

PUSH / PSH

The microwave door needs to be pushed shut to latch properly

Sabbath / Sab / 5Ab / 5A6

Sabbath Mode is active — microwave operates in a restricted manner

SE

A button on the control panel is stuck or continuously pressed